Leaderboard
Popular Content
Showing content with the highest reputation on 20/06/19 in all areas
-
Regardless, if it's not as described eBay have a great returns policy. Nothing to lose imo.1 point
-
no its to make sure the code entry is clear. Always tell clients the code is 0xxxx then they cant cock up code entry1 point
-
cant use 0 in code as its the clear button as a side note use 5 digit codes g2 as 9 available digits doesnt give 10000 differs1 point
-
All the information needed is in the Installer manual, one thing it says is that Engineer codes should not include the number 0.1 point
-
0 is clear on this panel1 point
-
Yes any tampers you have open will indicate fault1 point
-
Try recycling the power1 point
-
assuming as you say 0abcd then its not on default codes. But I only know the uk panels and they may have different defaults. I think they are printed on the pcb in the aerial area. if the code was correct it wouldn't wait for any more digits1 point
-
Did the default codes work before? I take it you didnt change the code? You could try recycling the power completely1 point
-
reset the alarm by entering the user code and disarming the system you will be able to access the engineer menu after that1 point
-
The thing is, you might be totally legit in your request but we don't actually know that or have any way to verify it. Also if we were to give this information out then anyone could access it, Obviously then there would be no point in your security system.1 point