Leaderboard

Eol resistors are for End Of Line use they shouldn't be in the panel expander etc. If the flex supports seol then you would out this at the end. I haven't looked in detail at the existing wiring

I appreciate the professional installers on this forum, and I understand that my situation may seem less than ideal. I want to assure you that I am doing everything I can to improve the current circumstances. This situation is not intentional, and if there were a straightforward solution, I would have implemented it already. However, there are some challenges that will require time and effort to address. Your advice and guidance are valuable to me, and I truly appreciate your support. Thanks, Mark

dunno, TBH I couldn't give a Castlemaine 4x ?

Normally your final exit doors would be 'final' you entry route zones would be exit. The use intruder for the rest not on the entry /exit route

Use one of these at far end and link two windows , perhaps you can seperate them this way rather all the windows on one circuit https://www.citysecuritysystems.co.uk/honeywell-dodt8m

DEOL (Double End of Line), will never work correctly without the shunt resistor across the zone in the device. You will also not find a panel that supports much more than 3 devices via DEOL. Your current system is SEOL which you could get away with that.

You say it's not an option... but that's what I would do. Wouldn't entertain all that stuff on one zone.

You will need 2 resistors if this is a galaxy on deol

Yeah

Yes a daisy chain the resistors at each end. However if the runs are short they won't be needed

Transistorised. Handy Little Relay, Bentley or Interface Solutions are some brands we get here. Not sure were you would shoehorn these in mind you, as for our standards it should be within the tampered enclosure. I'd just take wire from straight from the controls for this reason.

you will need a relay as norm or common the negs