norman
-
Posts
17,568 -
Joined
-
Last visited
-
Days Won
313
Content Type
Profiles
Forums
Events
Downloads
Gallery
Blogs
Everything posted by norman
-
Marquee attempted intrusion. Alarm solutions?
norman replied to Tempsc's topic in General Security & Fire Queries
I'd be looking at external beams -
Used to gently but firmly bang on the window for the low tone and press the tester simultaneously for the high tone, as above I dislike these more than shocks.
-
Oh I don't know about that, I've seen Al Yeti logged in in the early hours...
-
Hello and welcome, have a read of the rules and apply for trade.
-
All down to risk, a dialer should be set up to send a test signal imo but that usually adds cost.
-
Lol, Hello
-
Can't remember tbf, but a lot were generic modules in those days
-
Yes points towards the wall
-
Yup transparent iirc
-
"N" and "D" Markings on Shock Sensors
norman replied to Eugene's DIY Den's topic in !!..DIY Installers..!!
Yup, usually by window fitters thinking they were alarm men. -
eyes like a shithouse rat.
-
Pyronix enforcer
-
"N" and "D" Markings on Shock Sensors
norman replied to Eugene's DIY Den's topic in !!..DIY Installers..!!
Used to look after loads of those, they worked fine tbf. -
So do I.
-
It's youth slang for sorry I must have been wrong old chap, please accept my apologies and I'll take myself outside and give myself a jolly good thrashing.
-
If the memory has dumped then it also needs a new NVM battery
-
My bad sorry...
-
Very well, but you'd save money straight away as a company would only change the batteries every 4 years. The XPC is most likely a dummy external siren as these were sold as monitored systems, sold and installed in the main by subcontract sales companies in the early 2000's so having one non monitored is a bit of a waste of time. Just imo of course.
-
Still working for DPR?
-
How long ago was it last serviced?
-
Unfortunately, and for obvious reasons, we can't advise people how to do this, likewise it will need reprogramming for your requirements in any case. If you found the code to this system then potentially a lot of other systems by this installer could be compromised, how long ago was it under contract?
-
I'd suggest a reputable company to come and programme it for you, they will need the original installer code or they can crash and reprogram it. Get it serviced at the same time if it's not been done for a while (12m is recommended) and this will ease the pain of the call out to a non maintained system. May also require a new back up battery if its older than 4 years.
-
I'd suggest zone 8 is programmed as spare. How did you test it?
-
If that's where the existing reader is connected to then yes.
-
It requires a simple volt free contact, the reader is powered but the output to the panel is volt free.
