Where is the site? Give us a shout if you're still stuck.
As norm said, link out all safety and see if it closes, if it does bell out each pair until you find the open circuit.
As James, new battery at that age. If that does not clear the fault then you can try the monitor hardware, think its a local setting, not sure its in a wintex menu.
No of course, but I assume the OP is not brain dead. This has happened to me more than once after swapping a battery after a long mains fail. Tech know about the issue.
Maybe not. The prem has a bit of a bug, go into 'Monitor Hardware' and turn off Battery monitoring and exit engineer, it should now be clear of the fault. Now enter engineer and turn battery monitoring back on. Should work.
still no confirmed if they check which end is contacted and pop the other.
We have had to fit beams on a few sites due to being rammed with fork lift and not activating the contacts.
I would agree, but a wouldnt last long enough being told what to do etc to get to that point. Saying that I take home a fair bit more than any of my mates and no they are not all paupers
Those 15 hour days take their toll on body and mind! I do 10-12 hrs most days, but you get used to that and if you can get a couple of those hours done at home it makes it easier to live with.
Good point.
I had to remind myself a while back that we work to live and not live to work. Atleast thats what I told myself when I was in Las Vegas and Cancun this summer
That is not correct, the grade makes no difference to the amount of contacts. If the shutter requires 2 due to size then it gets 2. We tend to go with a contact and IR beam these days due to shutter being cut or rammed.