MrHappy

perhaps not, who'd have thought 4 yr old sensor battery's would go bad... I neither rate the smartcom or the app.

A maintained Risco Disco is probably better than a new self installed Texecom one...

Hi, Before you spend days doing what is a few hours work... most DIY don't understand the basic operation of an alarm The alarm is working 24hrs a day, think of its as 12 & 24hr circuits 24hr, tamper circuits, in detectors, controls, keypads, bell ect.. these work all the time 12hr circuits, motion sensors & door contacts ect.. these work when you set the system For example should the tamper on the external siren operate when the system is unset, it will ring externally regardless of programming & the internal speaker will operate to alert you of tamper condition. To change your alarm over is 1 days work, to fault find your existing, replacing all batteries & external sounder 1/2 day.

Stay late at work, get some overtime in & pay an alarm man to set up it.... They should know hoe the different ext modes work & how to define which buttons does what the keyfob

It not a consumer product, You can buy a boiler in Wickes, I doubt Worcester Bosch would be very helpful if you called them for DIY advice?

batteries had failed, metal backplate + inner cover 2 batteries, 2 pizeos 2 circuits boards plastic lid.... would have been an expensive item in its day...

"Secom Fortress" probably early 2000's ? Binned it.

A Yale sounder is the only thing which will work on a Yale alarm It can probably be refinished or repacked to look less "Yale" However its a DIY alarm, the only time I see them is when they get taken out...

2 million, if it was worth double he might have considered a powermax...

Took this tat down- & thought of this topic

I call them PCB terminals ?

right'o...

what the dark grey cable ?

Google says 222 & 333 However it may have changed

IIRC, president macron briefly worked for Pete ? something about magazines left in the van....

Hi Ross, contact details in your signature only pls, (its makes it very easy for TSI personal details if your request it as some time in the future)

but have many words for surrender..

Kerching & your in....

its basically tat.... is the micro switch has wires join 'em if its on a pcb bridge it out with a solder iron

Welcome (leave while you still can!)

PM me the long card no. expiry date & 3 digits on the back. & you can be approved in 1hr

could be worse, at least your not Welsh ?

Its like ask jeeves , but with added swearing

Normally I'm one of the 1st to welcome new posters on board..... but your ginger!

pipe work marked to bs 1710 orange - 06E51 yes I've just googled it