al-yeti

Depending on what power you need for the fan to work , connect the fan black ground to negative / ground -ve of the power supply And connect the fan positive to NO or NC depending on which way you want it to work, And then common to the power supply positive +ve So that would.operwte the fan when the relay is triggered, if it's. Magnetic gate then that power arrangement would probably be setup via the NC route , or you won't use any power if there is an existing push button which you can wire across it without any power arrangements Or you will be probably blow it all up if your not understanding it correctly ?

Could be jamming as JW says Cha be the battery in zone 2 And did he take a ladder up to the bell or he just bell tested the ring? Anything new installed, wireless doorbell heating controls with batteries?

I was going to say is there a comfort light setting, but bell is wired right?

He definitely replaced the batteries in the external bell? Or thought they will be ok

Ah man that was my next move , I assumed he missed that hence wanted the pics Your just to fast

To be fair as diy , your looking at diy so hence went for ring , Otherwise as others say....

Can we see picture of siren connections and bell , and proper pictures please David Bailey stylee , if you remember him lol

Ion is not bad for diy if you already know the scanny menus generally You quote the orisec? And texe? Both more difficult and the euro with zem complicated for diy ? What you saying blood?

Diy , one way scantronic ion range with free app base Everything else will be junk or need installer or tech support Unless someone else remembers anything else Otherwise going to the depths of diy ring?

Diy?

It's old panel dude , just like anything else it may do the job if it works for a bit , but realistically I am sure as SW would say not using a Nokia version 1 to post your messages ....... DIY although one way I can only say go scantronics ion which still uses a free based app system and is less complication other systems Others that are free either poor hardware or complicated programming

Reprogramming it all is best , to make sure it all works to how you want it to, but If you got the budget get rid of it when you can

Don't you have to set the zones up for part set first? In settings ? Then that might work ?

Keypad tamper is open

Lol , I here Sia will fit a decent dimension

Hkc SIA secure it all https://secureitall.co.uk/

No from what I know, but I was thinking he wired the loop wrong so back to start

As above G2-12 or whatever size you need?

So disconnect everything and close the tamper loop aswell that way you know everything is how it should be

Nah man that's just odd companies that do that, Different code and lock all panels is best ?

As jw , but pay him to default codes and lose all support from him or them ....

You missed some settings If your pirs are not using a common tamper loop you must set the zone eol section on the panel accordingly option 21? And if there was no bell tamper problem previously then you have wired the bell tamper incorrectly , or there never was a bell tamper and you haven't closed the loop , you picture of bell connections before swap and after?

So the mesh would work? If you place the receiver in an IP box outside each building for the intruder ? Texecom? 25m

How much movement and why can't you secure them better ?

Unless he uses ha system which provides that but decent stuff might cost 40k ?