al-yeti

You fitting neons under your van? Wide boy eh?

What about the ir, quite dark on edges , how do you get better spread

You need to get out of that office

Could still do with a decent cat5 stapler though , it's rough trying to clip through a loft spaces lol You all using clips? Or p clips? I used some cable ties with eyelets for bunches works ok, or is that a no no aswell?

Took one out A few weeks ago , panel was trying to light a fire it looked!

I experimented on some cat5 stapled on bench perfect every time , soon realised cat5 isn't like 8core doesn't keep its shape aswell , clipped it in the end Also if wood is very soft staples don't hold very well depends on type of wood aswell Is there an adjustable gun? Ie Staple sizes

-- means deleted I thought & - is learn mode Or is that another model? Where's the doc? Either way it did my head in, I took it out a fitted a hw8 instead , scantronics wireless I find alien , at least the old stuff....

Panel battery? When was last service?

Virgin probably installed it from where there t was situated , if you cause a fuss they will probably come out and install it cheaper , otherwise you pay full for an extension whatever there charge is

Why can't you just get a local engineer to link the two sockets ? Or run a cable internally ? Either way you have to pay to do it, or run and connect the cable yourself

Possibly as above the relaybhas been programmed to do something under certain conditions or something , if that's possible check what the relay is set to do

Next to you mean?

He was just confirming that output is for sound to keypad Chime is in manual ? Which came with panel in this case

No your incorrect you must have done something wrong , that gives you fault tones and exit entry and so on , only follows bell on intruder alert as such Sounds as though you connected it up wrong as there's two terminals for the speaker , easily connected to strobe if your not looking Either way speaker terminal gives you chime , exit entry , fault tones , I fitted loads of these in the past , so you wired it up wrong or something These panels are really basic in some respects but easily damaged if not experienced enough

Yes so the bell output is powered so you cant connect speakers to it I thought on that panel there are two terminals for the speaker not one?

good point though geezer! Op what did you wire it to? And what was exact model Either way it's normally one of those problems

The sonit is a power sounder not speaker I thought, you cannot connect powered sounders to speaker outputs and you cannot connect speakers to power outputs For speaker connections generally a 16ohm speaker is what you should have connected to the speaker output Sounders are normally connected to the bell output or a power sounder output but again be careful as to where and how you connect it if negative trigger then one leg to positive and other leg to bell output Using a powered sounder on the bell output also has to be checked for its current consumption , you cannot put to much load on the bell output But in general for those panels use an additional speaker on speaker output calculating what your doing I used the word "power" for sounders so you see the diff with normal speakers otherwise it's not said that way really Chime will work if chime is on when panel unset as you said it will chime on keypad and speaker

I in a diff country , but same island as you lot !

I thought competant was limited to your own property?

Ah beat me to it! As he said resolve your power issue I would check again your settings you may have missed something , did the place. ever use a pstn connection? How did you drop each line?

Didn't think you need to power Rios down if it's the com on the panel , just power cycle the panel, If it doesn't work save the configuration and remove one line at a time to see how many modules get removed this would prove your theory that there is no other device somewhere extra on the line But as above pstn otherwise