Jump to content
Security Installer Community

al-yeti

Trade Full Member
  • Posts

    9,306
  • Joined

  • Last visited

  • Days Won

    120

Everything posted by al-yeti

  1. Nah man lol was British thing You see the Vulcan documentary btw
  2. Lol no , single use , drop whole load into ocean to detect subs
  3. Strange times those , I had a part time job , dowty electronics , testing disposable sonar
  4. Lol disposable culture isn't what your saying , anyhow the keypad is going to give you trouble.
  5. What device you use to comment on forum.android or apple just wondering lol No struggle in knowing that keypad is going to fail further dude But by then easier to replace .....
  6. Changing code won't last long , your wasting your time and effort What device you have to post on this forum , Android or apple?
  7. al-yeti

    g mansell

    Only cos customer won't upgrade yeah?
  8. Then swap the panel out completely if your competent, I assume you do upgrade stuff in the IT world
  9. Diodes are good man You didn't test them come on , diodes are good lol
  10. Makes no sense More like at some point there was a price war , so then the £199 brigade thought about making a fiver on each one or something Removing them permanently is best thing Although bulkier the texe all in one is a far better panel imo
  11. You know it's going to fail again don't you?
  12. I remember that topic somewhere .....
  13. https://www.securitywarehouse.co.uk/catalog/intruder-alarm-c-36/movement-detectors-c-36_116/all-c-36_116_37/texecom-premier-compact-qd-p-3766.html
  14. Your panel uses the resistors it has on it , PIR either have them fitted or there built in Like I said you said budget is good so wouldn't see why you would go for the is312
  15. Lol , any but if you going to spend £20/30 on a new PIR then forget these ones Is312 is a replacement for what you have But for your budget a quad PIR texecom or optex are better
  16. So swap the board with another PIR dude , fault should follow if it's the put, meaning from another room
  17. So your saying the fault now is permanent? If you put it back altogether alarm won't set ? Due to permanent fault on that circuit ? Or you tested incorrectly? Not that our can't be at fault , I would have just swapped the boards over with another circuit by now , or compared it to another circuit the same way depending on lengths
  18. 2.2 what? Did you change the range when you read that or left it on the 200ohm range If you get good reading on the cable , and not correct reading from panel and fault is intermittent? Maybe you didn't put cables back properly , I doubt the resistors can go faulty
  19. Are there resistors in the PIR? Or wires just striaght into the tamper and alarm terminals?
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.