al-yeti
-
Posts
9,437 -
Joined
-
Last visited
-
Days Won
129
Content Type
Profiles
Forums
Events
Downloads
Gallery
Blogs
Everything posted by al-yeti
-
You got a picture of where you put resister?
-
Classis is me lol So enable in menu 48 , and then enter engineer code But OP more than likely you don't have it so try the resistor and then you might be lucky if it's all user reset
-
Alien DVR 654K - cannot stop beeping following power cut
al-yeti replied to Alan Richardson's topic in CCTV & Access Control
You ok yeah? Lol -
Thought it has to be enabled ? While your stuck get a resistor and put it across 1k and it should stop it from throwing the error until you work something out
-
Think he selected wrong forum , he discord is what he uses normally
-
You using power Rio?
-
SimpleGuy
-
Alien DVR 654K - cannot stop beeping following power cut
al-yeti replied to Alan Richardson's topic in CCTV & Access Control
Not really Common for fan to make the noise If hard disk doesnt spin up common for hd failure rather than PSU All vague unless you test it all of course , you don't need logs and menus to test that stuff -
So it means setting b?
-
This is UK , we don't read anything , especially manuals until we desperate
-
But we already told you where to start? Are you basically saying you don't have a clue how to find the manual to atleast wire the keypad to the control panel If you can't get that bit done , I would forget Bout this .....
-
Insurance? So they don't mind you DIY installing not know what your doing ?
-
They make good money then ?
-
Then go for the door sensors marked 1001-1004 which will be the first four zones on the board (1003 not being used it looks)
-
Leave coms til last , mount your panel and keypad , c078 , and the coms boards should already be mounted hopefully Switch on and see what faults you get, work through one by one
-
You should leave this for engineers to sort out ......
-
You know ply will rot But you get sometime out of it lol
-
Welcome As long as Amazon and Google don't tie up, it will be a nice mess for a long time lol
-
This is the second bell? Or all wired up inside the control panel with both cables I never had an issue the plastics on the Delta bell , unless that backplate tamper screw has snapped the tab maybe possible Or as said Bel is faulty but then I would swap the modules round if easy for you , that way you will know it's not the bell module as fault should follow Leaves you with plastics and cabling issue
-
External battery?
-
Can you post a full picture of the bell with cover off ?
-
Get a 9651 in your case
-
What makes you think keypad. Works writing it? Or even working Seriously the panel is scrap How much was keypad
-
Chubb CA67 (not the same as an active 5)
al-yeti replied to Jack b's topic in Control Panels (Public)
Look for guardall countess or something like that -
Because reality even though it's "meh" texecon isn't DIY friendly
