Jump to content
Security Installer Community

al-yeti

Trade Full Member
 View Profile  See their activity

  • Posts

    9,564

  • Joined

  • Last visited

  • Days Won

    136

 Content Type 

Everything posted by al-yeti

  1. al-yeti
    Iron brew?
  2. al-yeti
    I guess I could type it out but I am going to be lazy , your just getting confused the word eol , ignore it , so then instructions are the same as what I said before White and green to tamper terminals Blue and yellow to alarm terminals Black is minus - terminal Red is positive + terminal
  3. al-yeti
    Ignore the word eol and follow what I said
  4. al-yeti
    Same as what I just said And ignore eol and don't put jumpers on them
  5. al-yeti
    White and green to tamper terminals Blue and yellow to alarm Black is minus - Red is positive + Aux DC fail because probably short it out
  6. al-yeti
    Maybe the wire cut also feeds an expanded somewhere and you have repaired all the pairs? Only ones that went to keypad?
  7. al-yeti
    I guess it's the doors not so much the detector lol , I still don't like them far to sensitive to be on residential and not sure why they fit them there
  8. al-yeti
    Maybe I just don't know what I am talking about ? Plus 1?
  9. al-yeti
    So then no big problem then , what's issue? DIY panel anyway lol
  10. al-yeti
    No man those oval things with cable premade
  11. al-yeti
    So doesn't have to go into engineer mode to send new engineer code?
  12. al-yeti
    Hate those Honeywell g3
  13. al-yeti
  14. al-yeti
    You in Spain?
  15. al-yeti
    That's what subbies do to get paid for first fix
  16. al-yeti
    Silent on panic setting?
  17. al-yeti
    Why does Logan's name say guest?
  18. al-yeti
    Commissioning? Like second fix? Lash panel to wall Keypad Bellbox Detectors Programming Testing All via lazy laptop where possible Demo for customer , and go get some grub if they didn't give you any .....
  19. al-yeti
    Well there's loads of old parts marked adt on eBay so as long as your security is just a DIY thing ,and not protecting much of value to you , should be all good
  20. al-yeti
    If wiring correct There's a screw near tamper switch , or you saw it in packet and didn't put it in , that will help push switch if surface behind wasn't even You don't need to remove bell , just put screw in and turn it to adjust switch slightly and you will here the switch close quicker when cover is pressed down Assuming it's this , but it is normally the problem
  21. al-yeti
    Grade 2 easier to do than grade 3
  22. al-yeti
    Strangest comment so far .... But keep going
  23. al-yeti
    This bit most serious comment you have written and explains the job, so in this note carry on Good luck to someone who takes it over lol
  24. al-yeti
    Veritas will be difficult even the electrician's can't do them fully Start with Honeywell g4 - 9651 - galaxy g2-12 - then dive into a dimension on left hand and premier elite in right at same time
  25. al-yeti
    I do a bit , hate the bell boxes high up never understood why they do that , bunch of nuttas and muppets
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.

  I accept