al-yeti

Commissioning? Like second fix? Lash panel to wall Keypad Bellbox Detectors Programming Testing All via lazy laptop where possible Demo for customer , and go get some grub if they didn't give you any .....

Well there's loads of old parts marked adt on eBay so as long as your security is just a DIY thing ,and not protecting much of value to you , should be all good

If wiring correct There's a screw near tamper switch , or you saw it in packet and didn't put it in , that will help push switch if surface behind wasn't even You don't need to remove bell , just put screw in and turn it to adjust switch slightly and you will here the switch close quicker when cover is pressed down Assuming it's this , but it is normally the problem

Grade 2 easier to do than grade 3

Strangest comment so far .... But keep going

This bit most serious comment you have written and explains the job, so in this note carry on Good luck to someone who takes it over lol

Veritas will be difficult even the electrician's can't do them fully Start with Honeywell g4 - 9651 - galaxy g2-12 - then dive into a dimension on left hand and premier elite in right at same time

I do a bit , hate the bell boxes high up never understood why they do that , bunch of nuttas and muppets

Nah, this means you can probably fault find , so qualified.....

If you don't use it, a d don't think you need security , switch it all off end of story I assume you didn't have it installed and was already there , cats or no cats alarms can work with pets if make adjustments All depends on how much you want to spend on it and wether you think yourselves or anything in the house worth having some kind of protection

Hardcore What was it then? Ion40 ?

On a side the galaxy dimension panel wasn't made for the diyer Lack of information is more about lack of knowledge, training and experience So other panels you will find same situation where you don't know what it can and can't do

Would accept both

Ok dude I remember the external coms devices and cards

The versions are upgraded for development and sometimes correcting earlier glitches Version 7 example was superseded within week I think and so on Firmware easy to do , just buy it on a stick or if you can get the files there are other ways

That's what I thought C for confused dot come in my case lol They both have Comms on board tho

What about the C and the D?

Turn battery on And put on SCB mode

Where did you get bell? Is bell tamper closed? Does bell have jumpers you can take picture of Actually I see the jumpers

That's the first move to try make sure your bell is working But wouldn't the bell wait for the tamper to close and he's forgetting that?

Nothing happens when you do what?

Bell and strobe would be tied together into the normally open side of the relay , then common relay to 0v , I think lol The tamper you need to for now ground it in the bell if it allows so it ignores it , I think lol

Seems as though you can't programme as above So you need to use 0v +12v Then the relay for the bell trigger , which drops bell trigger to 0v when siren goes The tamper could be used on a zone in defence mode , look at page 11 , although not a tamper it can act as a 24hr armed zone , but you would have to mess around to make it work

Assuming that zone on the back is programmable it might work , you also have an onboard relay which could be used for a bell trigger depends on what it does

Unlikely anyone uses that alarm Anymore pictures or a link to the installation manual ?