al-yeti

Yes but your going in circles now read all answers more or less what they been saying all along

You can disconnect the tamper aswell and use that on a tamper circuit Either way you can't use that circuit board on the speaker output simple

In new one disconnect the speaker from the circuit board and use it as you did your old Or swap the case damaging the tamper switch won't matter Or use this new one as an internal bell and use it on outputs and keep broken one connected as is Just swap the case as said above

Yes pay dialler DIY dialling It's DIY or installer with arc

You can dualpath DIY Just buy a dialler and a GSM SMS unit and stick them both on , some will even poll for you , with enough inputs you can even get the GSM unit to message on line fail Other than getting an installer and monthly contract you might as well forget about the arc

What you talking about dude?

So zone 9 has an expander on it Sounds like an abacus split lol only 8wireles zones connected to one zone input ? Where that bloke DIY swb when we need him........

I fixed one recently an elite , similar system , has an external bell was installed by a builder not bad lol, freaked me out why it wouldn't set The builder clever one put the garden door sensor into the frame on a bifold after years slamming the door damaged the reed , I thought that was it but theres a gap behind the magnet side and the magnet itself and popped out from behind into the frame so not allowing alarm to set and always showing active Standard flush round magnet mounted on pillars into door , groove in door is where magnet was

What has engineer said on three visits ? Has it always said same fault ? Could be a fault on the cable How do you know nothing is connected to zone10? Can we see a picture of what you mean by "according to my installation instructions" ?

Panel probably needs to die to Did you check the forum listing for installers in your area , sure someone will be happy to quote for replacement https://www.thesecurityinstaller.co.uk/community/forum/268-uk-security-installers-by-regional-police-force/

Your better off just swapping to an ion40

It's probably the main battery aswell Get alarm looked at if alarm is important to you and them by an engineer

I never rated the sd1 etc allot of failures out there

In acknowledge settings is it set to acknowledge once ?

Loud outside siren won't do much for you lol no one cares much Inside siren nice and loud that you can here outside would be cool lol Dual path monitoring maybe GSM/WiFi or Lan connection Glass.break sensors are naff you trying to protect a large area without use of shocks to save money I reckon Show me da dollars man , the sterling , the jewels None of above is cheap anyhow back to reality to DD questions above

What's this mean dude? I just a mere blagger and don't understand

No one locks anything except me

You paying electrician to be a labourer ? He has to know how to do it himself as jw said

6wire no big deal , in fact four wire will work to

Hi No installer in there right mind would fit a 9452 , it's obsolete Try eBay keeping looking for one until you find a other scrap panel then try me fix it yourself if your competent Otherwise replace the panel with something like a 9651

Texe app DIY or installer?

But you seriously don't want him to keep the risco disco?

Lol

Commlit?

Sold as DIY tho