Jump to content
Security Installer Community

al-yeti

Trade Full Member
  • Posts

    9,332
  • Joined

  • Last visited

  • Days Won

    124

Everything posted by al-yeti

  1. That will cost money tho?
  2. Just search visonic ADT on eBay plenty available , used and new But you need to find out how much ADT charge to reset it for you , or you can try and default it yourself
  3. Plenty visonic ADT on eBay tho......
  4. You trying to protect to protect garden shed????
  5. It's junk in today's world Waste of time trying to fix
  6. Points instead of zones? Emmmmmm If you have data pirs wired , advantage is everything is called a point , for customer better that way Other than that don't know lol
  7. Exactly You can't have two devices on one one zone or point , each device has to have its own zone or point If you mean can you have a wireless PIR on a wired zone like zone 1 onboard it can be wireless instead Yes you can turn them off, but that you can do with part set A or B or even setting zones up on blocks if you have other uses Just add all your devices and those pirs you want to exclude on part set a just select that option in each point or zone and it won't arm on part set
  8. You need scroll until it says add to point number /zone from memory I only done this to a couple of sites because customer wanted it all common names
  9. No Are you not going to Add device Add RF device And so on ?
  10. Unless it's wireless assigned points then more, but you said that maybe lol
  11. Thought you said when linking wires out , the zones clear?
  12. Having said that , you could walk test an incorrectly setup Honeywell DT , it responds to walk test and doesn't on alarm , sounds weird but I seen it happen Yes , gives entry exit on tone Where did you get this stuff any way , are you in Ireland?
  13. No But what difference would that make? You only want to temporarily disable it So change the output or remove bell trigger and you done Lol it's funny but a interesting DIY way of doing it You have engineers code so just remove the bell trigger and remember to put it back
  14. Only thing with using a wireless siren you need to hold rear tamper in or wedge it if you walking with it The wireless keypad are very handy tho....
  15. Welcome to planet of alarm gorillas
  16. Single eolwould mean put resistor back in PIR if you removed it
  17. Forget firmware update no point Now you know wire links allowed faults to clear because it's not setup for resistors Possibly But carry on , if you manage to programme it fine If not you can use without resistors and global tamper if it has it DIY no big deal how you do it Also you need to remove the resistor from the PIR , if your doing it without resistors, If you join and open wire atnpir end that should open and close the zone , perhaps pirs are shot
  18. Put wire links instead of resistors and see if anything changes
  19. So if you disable tampers , then might be as Swb says the seol config and resistor combination?
  20. Label your wiring so you know what goes where Remove all the zones and get some resistors to fit at panel and prove the panel is working , resistors have to be the cheap bit Once lights go out and add a zone back at a time Alarm dudes on this panel is there a way to change eol etc ? I wonder if that's the issue
  21. Can you upload a picture of a PIR wiring
  22. It's two wire sensor on movement dude
  23. H , he sells stalking info on ebay
  24. 7 quid from eBay Italy if you can can get shipping deal done however you're right Eaton probably want 70 quid 7 quid from
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.