Nova-Security

R8 has flash strobe on set Forget that just read initial post again

Its an old touch lock ins-047 300101 http://www.paxton-access.co.uk/docs/Instructions/Archive/ins-047.pdf

eurosec is neg tamper return, will need a neg feed to TS

yes zone type 17

Use a link to an output

Dont go of what you hear.

Not a dig, but "Do you own a Multimeter" Resistance readings for circuits is the easy part, and something than should be do regardless of the NSI / SSAIB

Does not matter for sensing the amature, the dimple you'r on about is a spring is designed to push the amature off the lock when no power to lock, and is to be fitted furthest from the door hinge.

Its called Hall effect

Being looking also, like a few Elan, Loxone but KNX standard seems the best one at the moment http://www2.schneider-electric.com/sites/corporate/en/products-services/product-launch/knx/knx.page

https://en.bitcoin.it/wiki/Mining

Could have 150k of Bit miners Everybody says the security industry is based on re-occurring revenue

The reporting time is defaulted to 15mins, so when you have first set it up it might not of registered the ip address with texecom for 15mins

Same for some other devices on the market then, not controls.

And bike rack...

Funny that as they are one vehicle that holds money longer than most.

I meant the equipment to capture the signal and turn the alarm off. My mistake

Cant see it happening for a couple of reason's 1) Most yale alarms are on houses that couldn't afford a proper Grade2X system, that why they have purchased a DIY kit. 2) If you have the equipment needed and the know how, then your probably all ready employed in the IT / electronics field on £30K + so why would you want to target the people in 1. Also if the Yale alarms are installed DIY and not covered by a maintenance contract by a Co for the NSI or SSAIB firm, the insurance Co treats the premises as if it hasn't got an alarm (no discounts)

Replaced one about 3months ago made by BSB

in this game if its 8 years old its probably been super-seeded and not made anymore

Why run the poer to the relay at the contact and back? Run the contact wires to the panel RB007 trasistorized relay then its only doing 200m

Hes using a relay to switch it, so the power must be local to the LED so volt drop doesnt matter. 12vdc 1k resistor

Seen one of ours on a list that a certain distributor / manufatory gives photocopies out to people, funny really as its a code we use for a subbie to put in to set a system up, then when we go to commission the site its changed. Not used that subbie since and will never use again as the trust has gone. And we know who it was as every subbie has there own code issued. Agree with that,

Galaxy RSS has a place on comms server where you put your UDL code

We went to take over a large site with a G3 on it, had engineers code changed by losing company connected up the laptop, and it wouldn't connect. in the g3 panel there is no pace to program the downloader ID or system ID so unless you know them you are not connecting to the panel unless you crash it and reprogram it. When we install a new system them site is then sent to our server which generates a system ID and puts our downloader ID in to the panel, then if we take a laptop to that site the only way to connect to it is to export the file from our server and import it on our laptop. Might of missed something but where on a G3 can you programe the downloader ID ?