Jump to content
Security Installer Community

Vini

Member
 View Profile  See their activity

  • Posts

    62

  • Joined

  • Last visited

 Content Type 

Everything posted by Vini

  1. Vini
    Ok; sorry folks! - Do I need to be in the panel/move any wiring? - 1001 thru 1004 seem to be pretty much essential...? Would changing these have a detrimental affect on the operation? I just need to nail this and im set...
  2. Vini
    So I can change 0001 from Fire to DetRst, but I'm not sure how link that specifically to what is Zone 1004 in this case... I am not entirely sure which Zone 1004 is in the panel... Do I even need to be in the panel!?!?
  3. Vini
    I've read the book of words and it's got me confused... My outputs; 1001 Set 1002 SPK Driver 1003 Bell 1004 Strobe 0001 Fire 0002 Panic 0003 Intruder 0004 Assist 0005 Omit 0006 Fault 0007 Confirm 0008 Tamper Is it simply a case of changing 0003 Intruder to DetRst? Would that change all my Zones set to Intruder to DetRst, and if so, is that a problem? I'm guessing I cannot set a specific zone to a specific output via RKP. Looking at the wiring within the panel, I am able to identify the Viper, however, cannot see how changing the wiring in there would help. Help?
  4. Vini
    The LED was off when closed/clear, after triggering the GLX during testing, the LED is constantly flashing.
  5. Vini
    Is that drop power to the GLX, or panel? Bit of a pain really - can I disable the LED totally, given its location it would be fairly obvious if that was the PoE?
  6. Vini
    Finally got round to sorting this tonight, during testing all was well. But since it has triggered, the LED has not stopped flashing. Arming/Disarming has not helped. Anyway to sort/reset this?
  7. Vini
    I'll look out for that. Thanks for the tip with the bare wires too. This is just hooked up temp so I know what goes where whilst the room is refurbed.
  8. Vini
    guys!
  9. Vini
    My hero It's a brand new Viper GLX, I don't understand the above, but am assuming I don't need to do anything funky?
  10. Vini
    Hey all, just in the process of rejigging the alarm, and it's been a while since I've tinkered with the wired stuff... I want to switch a single PIR for a Shock on my G2-20... Forgetting the 'quality' of the wiring, how would this transplant over to the Viper? And resister location?? Thanks in advance!
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.

  I accept