datadiffusion
-
Posts
12,329 -
Joined
-
Last visited
-
Days Won
110
Community Answers
-
datadiffusion's post in Scantronic 816 was marked as the answer
The 816 was sort-of alright in the sense of less to go wrong. But so utterly pointless with the 9751 etc... around the corner.
-
datadiffusion's post in Scantronic 9800 Bf Error - Can't Silence Alarm was marked as the answer
If you want to keep your neighbours as friends, I would call an out of hours pro now.
The battery is faulty, almost certainly dead after all these years.
If you find the main control box, and disable it, then it's possible the external siren
will then start to sound for up to 20 minutes.
Smashing it up, or disabling the keypad, will not help I'm afraid.
-
datadiffusion's post in Scantronic 9651 Adding 9954 Expander was marked as the answer
9954 does not work on 9651, simples.
-
datadiffusion's post in Scantronic 9651 'checking Bus' Message On Exiting Engineering Mode was marked as the answer
There is no issue, although on a 9651 the only relevant bus checks it's doing are for keypads. A longish wait is normal, I upgraded a 9853 last week with a second keypad and xpander and that takes about the same time to get to 'exit engineer?'. Other than mains or battery, if there are faults it can see, it won't let you exit.
The only specific bellbox fault this panel can detect is an open tamper.
-
datadiffusion's post in Adding Rfx08 And Four Buton Telecommand Scantronic was marked as the answer
Aren't there various oddball rolling / non rolling code versions of the 727 - that are not obvious without careful inspection? Perhaps 16 had a newer firmware / RF chipset?