Vick

after valuable advise from forum members i have replaced the accord xpc control panel with galaxy 16 plus panel with RIO zone expander system is now working but I would like to wire a AG8 sounder to the novagard sounder i would be grateful if some could assist with wiring the second sounder to control panel diretly or to the novagard sounder. I have attached copy of my current wiring below.

My home and family is worth more then anything else. I have a old Galaxy 16+ panel which I have reseted to factory setting and will try and reprogramme this. I will get RIO zone expander fitted to this panel. I am getting line failure error and can not figure out how to clear this error. I have read the engineer manual and trying to digest the information.

This is a old panel, is there a expander for this panel? If I can use any zone expander then I don't mind getting zone expander as thus will be maximum £40

Pirs are made by guardtec and the doors are not installed yet but they will be upvc doubled doors with side lights

Doors operate independently. Pir model us guard technology and Manuel does not show wiring in series

Two bedrooms are on the first Floor. Extension has a pitch single storey roof. Just connect below the first floor bedroom windows

There is obstruction on middle of the room where the current extension is being built. It has RSJ and two side walls entrance to the extension is open. Does not have a door in middle. Pir does not trigger until coming to middle of the room There is obstruction on middle of the room where the current extension is being built. It has RSJ and two side walls entrance to the extension is open. Does not have a door in middle. Pir does not trigger until coming to middle of the room

It's not a bungalow living room is 10.5 meters long

I have a double doors at the back where I would like to wire double door contacts. Currently I have one pir in the living room and I would like to wire second because of the length of the room and the RSJ in the middle of the room. Currently have following zone setup Z1 front door contact Z2 back door contact. Now double doors Z3 kitchen pir Z4 living room pir now extended Z5 passage pir Z6 bedroom 1 pir Z7 bedroom 2 pir Z8 panic button I would like to double up zone 2 and 4

Why are everyone suggesting to replace the panel. I know I need to replace this old panel and I am fully aware that it is difficult to track down which pir or contact has se t of the alarm. But if I can I would like to use the same panel.

I want to double up the pirs in the new bedroom and a back door. I do not want to spend £100 on new panel. If I buy a new panel then I will also have to buy a zone expander which I can not afford after spending so much on extension. I would be grateful if someone please assist wiring these.

I have successfully wired deol accord X pc at my current address. I am currently extending my property, there fore required some assistance with wiring double pirs and door contacts.