james.wilson

has it ever worked?

there shouldn't be 2 pirs on the same zone so id guess the person that did it didn't know much and then wired them in parallel?

Following on from another thread I will post these pics in the mean time till I connect it up to a panel https://www.securitywarehouse.co.uk/catalog/elmdene-flush-mounted-stainless-steel-16-ohm-extension-speaker-p-5054.html

to be fair we don't know. The service co might we'll be correct and its lost in translation. I cant think what single tap might be though without a bit more detail

afaik its licenced and protected

yes as above 4g can be an issue, but id be looking at proving the panel with a test system to check it occurs in both panels and yes don't disable jam detect. I have had a 1070 with an aerial fault cause supervision issues. Had to replace the board.

also when you say 'preventing a reset' what needs resetting is what is displayed etc

hi

so your fitting a Dualcom or will you support windows uwp? no pressure like? redcare is the name all like, its old, I hate it cant do extended

I do have videos of redcare vs webway vs dualcom so yes

ill do that just after you fit a Dualcom at home... I don't do whats popular I do whats best

ta, I'm guessing an answer

When do I have uwp windows phone app?

you can have ip cams on webway

its subscription and yes by the installer

Its the webway app https://webwayone.worldsecuresystems.com/knowledgebase/conxtd

have you tested the bell output with a metre?

it does amuse me who trusts a Pyronix sensor after all that has been

well it looks like you have a tamper fault you will need to track down and a sensor or cable issue in the lounge

can you post a picture of the main board so we can see the wiring?

deep base or ip box?

Because Honeywell want you to buy a more expensive panel if you want the additional features

The G2 is popular that's why. I like it but prefer the flex and dimension

never seen jamming reported in a hkc. I'd check the device signal quality, missed polls etc. if it thinks its being hammer and its armed it should go into full alarm. But id be doing some tests first. Can you post the relevant log sections from the app?

voltage of a battery doesn't mean its ok. You either need to out some load on it to test its capacity. The reason its reading so high is because its just come off charge