Jump to content
Security Installer Community

james.wilson

Admin
 View Profile  See their activity

  • Posts

    30,536

  • Joined

  • Last visited

  • Days Won

    278

 Content Type 

Everything posted by james.wilson

  1. james.wilson
    if its an 'escape route' then yes
  2. james.wilson
    do they not look to you for advice on whats good equipment?
  3. james.wilson
    No it isn't programming. Out of the box it wouldn't do what ur reporting. Prove the panel by disconnecting everything then once proved add things one at a time. One option would be to wire the rear door onto 2 and link 3 and follow the same process if you don't want to strip all the wiring
  4. james.wilson
    agree with all of that.
  5. james.wilson
    check the resistance between the 2 circuit wires too
  6. james.wilson
    no it wouldn't (bellbox) on a walk test. But I do think it isn't a panel issue run a temp new cable to the 2 devices bet it doesn't continue I think its external
  7. james.wilson
    id say you have a cross voltage between the 2 circuits.
  8. james.wilson
    It has to be wiring if it was panel we would get loads of returns which we don't the optima has a very low return rate and then its usually because its been wired wrong and blown
  9. james.wilson
    Ah did you remove the wiring from 3 when you linked it out?
  10. james.wilson
    I'm wondering if your overloading it?
  11. james.wilson
    What happens if you remove the bell
  12. james.wilson
    how do you report fault (ie tel line digi etc) to the fire panel? Is the intruder alarm compliant to bs5839, whats the standby time of the alarm (as the dialler will be powered from it if wiring direct) etc etc etc
  13. james.wilson
    If you have provided a 5839 cert then wiring it non 5839 kit would make the cert invalid.
  14. james.wilson
    you have to have them as an approved firm
  15. james.wilson
    Imo manufacturer training, usually done by the employer not sure if you can get it on your own. I'm sure you can if you go to them
  16. james.wilson
    busted but hello T
  17. james.wilson
    that extra o. Dave log in as Pete its your turn....
  18. james.wilson
    Valid point though. I'm not keen on the gear tho
  19. james.wilson
    I found it interesting mate, especially the non perm leds
  20. james.wilson
    As above anything but what ur looking at But if diy that or Texecom
  21. james.wilson
    No it's just as bad
  22. james.wilson
    Again you have said that before. Btw forum works well when all share. Already have one open taker
  23. james.wilson
    well it is risko. You are a bit stuck having the worst pro gear.
  24. james.wilson
    and you didn't like the idea
  25. james.wilson
    you say that a lot ill shout then
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.

  I accept