Jump to content
Security Installer Community

james.wilson

Admin
  • Posts

    30,578
  • Joined

  • Last visited

  • Days Won

    281

Everything posted by james.wilson

  1. agree with all of that.
  2. check the resistance between the 2 circuit wires too
  3. no it wouldn't (bellbox) on a walk test. But I do think it isn't a panel issue run a temp new cable to the 2 devices bet it doesn't continue I think its external
  4. id say you have a cross voltage between the 2 circuits.
  5. It has to be wiring if it was panel we would get loads of returns which we don't the optima has a very low return rate and then its usually because its been wired wrong and blown
  6. Ah did you remove the wiring from 3 when you linked it out?
  7. I'm wondering if your overloading it?
  8. What happens if you remove the bell
  9. how do you report fault (ie tel line digi etc) to the fire panel? Is the intruder alarm compliant to bs5839, whats the standby time of the alarm (as the dialler will be powered from it if wiring direct) etc etc etc
  10. If you have provided a 5839 cert then wiring it non 5839 kit would make the cert invalid.
  11. you have to have them as an approved firm
  12. Imo manufacturer training, usually done by the employer not sure if you can get it on your own. I'm sure you can if you go to them
  13. that extra o. Dave log in as Pete its your turn....
  14. Valid point though. I'm not keen on the gear tho
  15. I found it interesting mate, especially the non perm leds
  16. As above anything but what ur looking at But if diy that or Texecom
  17. Again you have said that before. Btw forum works well when all share. Already have one open taker
  18. well it is risko. You are a bit stuck having the worst pro gear.
  19. and you didn't like the idea
  20. you say that a lot ill shout then
  21. It could be a few things but id suggest signal related, it may just need relocation
  22. if no recording available id assume those channels are not set to record at all
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.