james.wilson

I checked that, it isnt on log only Plus im checking the log, so if it was on log only it would still be there. Had a recent issue with 3 of our old plus units going into 72 hour polling failure. was told by csl to go to site and restart the units. No help. Turned out to be a fault at dualcoms end. Currently in a state of high confidence in these....

I need to test another, but fortunatly i only have a handful of the non paknet based dualcoms. I would prefer to test a grade 4 one, but im fairly sure we dont have one. We used red gsm when G4 was needed. I'm quite suprised to be fair over 4 hours now and not even a single path fail has been reported. Where is that document that says 3 mins lol Ill do a redcare Secure 3 and a webway next week.

Following on again from the LPS 1277 topic and after the dual path fail test on a redcare GSM this afternoon I did exactly the same on a Grade 3 Dualcom GPRS. Powered down at 15:20 9/3/12 as shown in this video. Last signal currently shown is the tamper from when i put the galaxy into engineers to open the panel. ie no GPRS fail or PSTN single path failures. Much less a confirmed comm fail (ie both paths down). System not put on test (as it wouldnt be in the wild if it was attacked. Exactly the same procedure as the redcare test. Unit is still powered down, im hoping that something will show up at some point....... Last Checked at ARC @ 19:12 9/3/12

anti Nowt no anti mask is about risk on the site. Most people do G2 afaik so to generalise that its weak imo goes against most opinion. I personally would go for contact and trap protection on the view. There is an en guideline that dictates this but its optional so far

if the shutter is that big then yes 2 contacts either in the same confirm group or in series is a good idea but not a requirement. Also if the door is dodge id also spec an active beam. agree with the trap protection of an overlooking dt

agreed you cant confirm like that

Had another request for LPS 1277 signalling today from the insurer rather than the broker. Anyone else seeing this yet?

http://www.thesecurityinstaller.co.uk/community/files/file/250-optima-xm-manual/ pretty much the same. If i recall the XL only gave a backit keypad

agreed staples used correctly are fine imo

it can do that now using the basic alarm integration. Just needs an output from the panel to show set status to the controller. If you need this i can look at knocking it up mate

could be done via android but it would need the app on the pc on site running all the time to actually open the door. Plus it needs paxton pro to get the web version which costs. Do you have any other gear on site?

paxton make a caller id module for net2, that way you can control and record access?

once its out ill have a play and see what i can do. The web app was a closed beta and i wasnt on it lol

no i cant port it to that. But when the new version of net2 comes out I should be able to do an android app for the same thing,

If anyone has a use this is a small app that will open a single door. Designed for use on a pc in reception etc to open a set door for a security guard etc that doesnt need full net2 access.

do you not think that when a govt in the future removes all the single lanes made from dual tracks, bollards, markings etc that they can claim they have improved road areas by 30% etc. Seems like a setup to con us all into thinking they have made more roads when all they did was undo the **** they have done to limit useability of said roads

lol