james.wilson

not on some they need the door closed at exit start

question OP, if its very important why have you cancelled the support etc on it?

some panels (dont know this one) need to see final door open and close during exit time. If open at the start it wont 'final set' on closing. timed will ignore door state at start of arm

agreed id say it programmed for final door needs to see it open and close to arm. Get it changed to timed exit rather than final door (unless signalling but im guessing not) or start with the door closed

if you start arming it with the door closed then leave is that ok? then if you start it with the door open then close what happens?

when you open the door when its armed do you get a delay? or does it go immediately into alarm?

Big end station is one thing I love, more room for comms etc

I should go back to hosting tsi on Windows nt4 with iis. It works still

It does that to allow full flexibility. You can use anything then off an output. All tones or leds or buzzers or hilos or etc etc same throughout. Other panels tried it with speaker out but missed the fact it isn't a limitation

Is it well old? Might need a restart if the circuit was in use, then went fault before spared off

Yeah

yeah van. I found out when we changed policy a few years ago and i was excluded from the fleet. Assumed i could drive vans on the car policy as its got work listed on it but cant. same with van fully comp cant drive a car third party. WOuld probably pass a producer etc but not a claim

bear in mind using a car policy does not cover you to drive a commercial vehicle 3rd party. ie our vans are insured for any employee to drive on company business. However i couldnt drive one 3rd party on my car cover

and the registered keeper

im guessing whatever is connected to A3 doesnt work very well? also you have a .5mm 2 core flex whats that doing?

you will need to either provision it from the phone system or program it

Ata converter then will give you a pstn port

You can convert using an ata but may as well get a device that is native, what service?

I'd suggest it's past it. But if you want to keep it I'd bridge the Reed and use the external connections only. But as its the oldest electronic thing in your house it must be time to upgrade or if your not fussed just decommission it You ought to look into wireless polling etc not just assume a signal will make it. The rf environment is way different now than when that was considered good

Brilliant Out of interest what do you reakon on the age of that logo top left?

bostin

oops

up the bonk!

yuk thats probably your problem