Jump to content
Security Installer Community

james.wilson

Admin
  • Posts

    30,578
  • Joined

  • Last visited

  • Days Won

    281

Everything posted by james.wilson

  1. Logan stop this please
  2. It's highly unlikely its been well maintained, few people want any sort of manual for anything that is. However assuming it hasn't been well maintained I'd go with Mr h's findings
  3. oh and the keypad is a 6?
  4. You won't have a Gal 90 doubt you have a mk2 keypad that's exec era
  5. No but its a lot easier
  6. No good for DIY but a hkc installer would upgrade to hkc Id addressable
  7. It's not in seconds op. You would need to leave it in fault and not acknowledge it for 55 mins
  8. There is a delay timer on mains failure
  9. You can still use eol just if your replacing then the sensors could probably do with it too
  10. If using pulsed dc drive you would only have half throw so less volume than ac drive?
  11. It's not dc a speaker needs ac. I wouldn't by choice run speakers with anything else. Speakers and drivers can be very electrically noisy. You will probably get away with it but still
  12. No I'm not ill ask tomorrow
  13. I'm looking forward to daves one
  14. What have you done!
  15. he uses hkc afaik
  16. Logan I removed a working one of these with lcd keypad ill send it you
  17. i wouldnt
  18. I'd start a new topic based on your requirements
  19. Don't even know the panel what is it?
  20. This post cannot be displayed because it is in a password protected forum. Enter Password
  21. Ca t 5 snaps at point of termination. If fitted as intended by idc and secured its fine
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.