Jump to content
Security Installer Community

james.wilson

Admin
  • Posts

    30,545
  • Joined

  • Last visited

  • Days Won

    278

Everything posted by james.wilson

  1. afaik other devices need the flash tool. I'm sure the spi key will only upgrade the firmware in the panel
  2. bell is bell - set needs to be one of the programmable outputs telephone doesn't matter a and b is 2 and 5 in the master socket
  3. It maybe your phone line converter. If it has comms in the queue it will keep retrying. dissing is disconnecting if you have dissed one of the legs then its not the device hogging the line. When you say engaged what do you mean, I took it to mean it was dialling etc?
  4. if you use home3 / home4 numbers iirc these will dial a phone there are 4 different tones depending on the alarm event
  5. got a pic of the side? My initial thought is molynx
  6. I'm fairly sure a 16+ can dial directly a mobile etc. It's been a few years since I've worked on a 16+ though. I'll check a manual when i get to a pc
  7. if you have programmed the digi side it won't work direct to a phone
  8. id assume then it wants a pulse to open? then time out and reclose?
  9. is the shutter an auto close one? I would also say it shouldnt be toggle as it will stay active until a valid card is presented or rte is pressed
  10. from a relay that operates when the system is armed
  11. the from alarm pair is an open close clean switch to show the paxton if its armed or not. the to pair will go to a zone programmed as keyswitch momentary
  12. it does give early warning of contact failure
  13. there used to be a member here that loved them. Bound to be lots in search
  14. not judging but this 'cowboy' set it up on the pc?
  15. assuming the new cameras are on the nvr ok then they just need adding to ivms
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.