BYE BYE

Evening all, Anyone managed to get the camera section of the Texecom Connect App working? I'm using HIKVision IP cameras but need an example of the "Image Command"

Nope, Like you figured i would wait for the app......and 6WB to break it first

Fair points both - thanks. I'm really after the Connect app etc. so guess i have a while to read other peoples upgrade woes before that is released... Mike @Texecom mentioned it could be released beginning of Sept....

Thanks James...I'll sit tight for a bit.

Evening Gents, So Texecom released Premier Elite v4 software at last and i'm going to have a go at updating my panel. (48) I have the Prem Elite Flasher Interface and JAA-0001 USB lead. So should be all set to go at some point over the weekend. Any advice before i get stuck in ? !

OK, panel upgrade is a plan then... Ill probably be back with my head in hands soon!!!! all

Good knowledge - thanks !!! I already have com IP but its a bit creaky and the app has never really performed well - coupled with the fact that sky only do dynamic public IPs, ddns is needed and that is a pain too. I'll consider tinkering around again - I saw that v11 had a stability fix for the com IP so may just go for that. - having said that I cant find it on the texe website. Is there an archive of these older firmware's available? The other thing is that i need a wireless solution for a garage and shed. If this were you -wold you swap out or upgrade ? Perhaps i just like the idea of "latest and greatest" firmware.

Morning All, First post here so please be gentle. I installed my Tex Premier 48 a few years back - not in the trade but am an engineer and our company does do security but not a Texecom specialist. The panel is a v9 and i have a plan to add a few more tricks to its bag which got me looking. I see that the panels are now called Premier Elite 48 but cannot for the life of me find a comparison / difference between the two. is it just firmware ? I have the relevant USB and flasher lead to perform an upgrade and access to the Texecom website to get the new firmware. My real question is can i upgrade my prem 48 v9.00 to a prem elite 48 v3.00? Failing that is there any mileage in upgrading it to v11 ( which i think was the last release) or should I just bite the bullet and swap out the PCB for an Elite version? in advance