job

thanks for the advice, I will check all voltages and resistance measures. I had thought it was an AC issue but just assumed that the battery with smooth it out. Might have to replace the AC unit

Yes tamper engineer reset is on, but that’s means an engineer reset is required after a tamper event, that wouldn’t cause all the zones to have a tamper event at the same time. I should have a photo this week of the PIR wiring and the PCB.

I don’t have a picture to hand. I will arrange and post once I’ve got one.

Just connected to the panel zones, no expander. 8 zones - all PIRs from memory nothing either side in the log. what’s strange is that I perform an engineer reset and it clears the tamper, it’s. It like there is fault that prevents the setting of the alarm again

Hi, I have installed a Texecom Premier Elite for a client (I can't access the trade area as haven't made 5 posts) 2 years ago. I have the PIRs wired as EOL with standard 2k2 and 4k7 resistors. On Thursday night and Last night, I have had a notification of zone tampers. I went to the site on Friday and checked the log and wiring. The log shows that all zones had a tamper alarm at exactly the same time. The same thing happened last night too. I'm not sure what is causing all zones to tamper at the same time, has anyone seen this before or got any points that I should look out for. I don't install many alarms, mainly CCTV or wireless systems. Can anyone suggest what I should be looking at? Thanks in advanced. James

Hi I have an agility 3 with GMS module & IP module The alarm is working correctly, and the app notify me of alarm notifications. What I have wanted to sort out is SMS notifications for set/unset events. I have a TESCO PAYG sim card in place with enough credit. The check balance function works fine, but the follow me won't notify me of set and unset events. I have set the SMS centre number, and defined the follow me numbers - ensuring the correct events have been selected. However on set/unset I get no sms messages. If I send an SMS to the panel such as <user code>ST - I get an appropriate response; also I get a message from the panel when test the FM number through the keypad. I have also made sure the FM Call All is set to Y in the installer menu. Can anyone offer any ideas ??? Do I need to enter mobile & SMS centre numbers as: 07xxxxxxxxx or 00447xxxxxxxxx or +447xxxxxxxxx Best wishes James