Tel3

Thanks Peter,,yes the panel still sounds..and have tried the factory reset codes and engineer code…but no joy,,like I have said there is a way of going back to factory setting by placing a link in,,but unfortunately on my rascal the link connections are not there.

the lights lit,are 2,4, tamper,,,also the day and mains lights,,,the tamper switch is working on closing box,as I have tried closing without power to panel to check it,,the panel is sounding,and no response when trying to reset,,I enter code,still sounds,I then enter code and #, but panel still keeps sounding and won’t reset,,I’d like to reset it if poss,,so I can try reprogramming it.

,,thanks for all previous answers and advice.,,,,,,Further to this guardall rascal super alarm,,the manual states that putting a link in ### this will put the alarm to factory settings…looking for ### on the board as shown in engineers manual,were it’s supposed to be, numbered 1 to 6 with no indication a link can be fitted..is there another way to put this to factory settings,,I hate to be beat on this…thanks

I installed this alarm,28 to 30 yrs ago,,worked perfectly,changed battery a couple of times,but this time,on taking cover off,I inadvertently did not enter code to silence sounder,and proceeded to change battery,and replaced cover,but alarm would not reset.,,,I have noticed on an internet engineers manual for this alarm,Guardall Rascal,,that by putting a link in the ###, on control board,this will put the system back to factory settings,,my question is,,after winding down the system,and putting this link in,,( I have no idea yet,how and where this link is on the board),,would doing this will the system stop sounding and showing alarms,and then allowing me to proceed with set up procedure in manual,,thank you.

Thank you.

would appreciate anymore suggestions on my topic,,thanks Anymore suggestions would be appreciated,before I attempt to rectify my control panel thanks

Thank you for your info

Thank you for your info

I have tried to replace the back up battery,which I have done previously,,,taken off control panel cover,,the sounders worked,,changed battery,,then replaced cover,,tried to reset system but would not reset,,,tried a few times,and removed battery and mains power off and on but will not reset,,checked all wiring inside panel,and nothing out of place,,is there some way of doing a factory reset ,it does not give much info in manual,,thanks