Jump to content
Security Installer Community

Monty

Trade Full Member
 View Profile  See their activity

  • Posts

    202

  • Joined

  • Last visited

  • Days Won

    1

 Content Type 

Everything posted by Monty

  1. Monty
    Use the out puts and progg to follow partition not sure how much current your sound one draws possible use smart relay just in case
  2. Monty

    Still using coopers/Menvier/Eaton/still like to wire where possible old school is the best 

  3. Monty
    Progg a bell delay long enough for you to carry out what you want to do then reset as normal ( remember to remove )
  4. Monty
    Would agree one to be replaced
  5. Monty
    We use Menvier dose drop out some times ( prob all do ) over all good site
  6. Monty
    Are you looking for the strobe to give you conformation of setting /unset coopers panels can give you a 3 strobe flash on both so might be in setting progg
  7. Monty
    Engineer on site means you have left engineer put in your code then ent ent 1
  8. Monty
    Take a look at the Ion 40 H good robust easy to use and secure app
  9. Monty
    Yes we did have a lot of keypads to replace then they withdrew the 'new ' keypad due to using batt to quick !! Only had 1/2 that did that but never recalled we still have them on the shelf but do we fit or will give us problems !!
  10. Monty
    We use the Eton kit ( Menvier )now badged Ion use 30 r and 40 H both have proven them selves ( most of the time ) also Memvier 40 with bolt on wireless all the same periphirels across the range and the new app for 30 and 40 is good and reliable worth a look at Tec back up not as good as used to be and never see a rep Allan M
  11. Monty
    We use the coopers M12 and fit remote sounders and an Expander PSU - along with Ion 40H remote access to sys tem with coms works very well and quick and easy to identifie fault/fire alarm not always so easy on the mains operated ones
  12. Monty
    Sounds like it's set up to lock the key pad out on entry will prob let you use a code to unset once entry timer has run out if this is the case just have to find the setting in DD243
  13. Monty
    Might have an viper one in the old parts cub will have a look see
  14. Monty
    the 1st panel we put in was a tunstall CPA6 in a school where we had the Electrical contract Quite a hard one to start on but made the next (A1 9000 ) easy
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.

  I accept