Search the Community
Showing results for tags '9651'.
Found 6 results
-
Hi Chaps Wondered if you could help. Ive a Scantronics 9651 with engineers codes etc. i recently moved a PR Sensor for decorating and tripped a fuse on the board. While out of use (awaiting fuses) I took the opportunity to remove the keypad and clean the contacts as several buttons were not working properly. Afterwards I changed the relevant fuse and despite having codes I’m unable to reset my system from a Bell Temper & Aux DC Fault. Any tips would be gratefully appreciated. many thanks Steve
-
Greetings all, need some help and advice plz. A friend of mine has a scantronic 9651 with smoke detectors fitted. The problem is he would an electronic sounder fitted because it only bleeps at the keypad. Is there a way to fit say a 12v roshni to the panel via the 12v aux or the n/o-n/c contacts. thanks in advance
-
I have 2 issues, firstly I want to setup the alarm part set B for night; so that it triggers the timer when you enter the hall, the problem is the hall is set as an entry route for the full set A and the other part sets (the doors are final exits..), so the only way to trigger the timer is putting the hall zone as a final exit too would that conflict with the doors/other settings? Is there a correct way about doing it? I don't want to put the upstairs PIR to final exit because it would trigger if someone went to the bathroom. I also need to replace the keypad because the one I have is broke & touching it can sometimes cause a tamper alarm, I've ordered a new but need a way to install it without defaulting the system (don't want to reprogram it again), is there a way to do this? if I turn the mains off and put the keypad in installer mode and just changed the keypad there would it cause any issues? Or do I need to turn everything off and reset all the settings?
-
Apologies for reposting what others have experienced, but in my case I do have (what is supposedly) the engineer's code, and I'm still being locked out. Display: "Reset Required > Sound Tamper" Lights: Power LED (green), Service LED (red) I've tried typing in both the Engineer's code, and my own but in both cases the display says the code is invalid. I suspect I already know the answer ("the Engineer's code you have isn't the right one"), but I'm just posting in case I've missed an RTFM moment, such as 'press x, then key in the code'. I'm not hopeful, but I'd be a fool not to even ask if there's something I can do without the expense of calling out an engineer. Thanks in advance. -
I have a yellow light on the control unit that states 'call installer' The log also reports "Tamper Z07 Rstr" which is the remote input panel This was after the property lost power and was hard-reset at the fuse box. Any suggestion is welcome -
Hello, I have wired an extension and been asked to add a couple of PIR's and Door contacts to an existing Bells only system its a Scantronic 9651. There are not enough zones present in the panel so have added a 9954 expander. Now the problem is that I cant find the extra zones, The system has 2 keypads, one with no link the other with id 2 link. The 9954 has no link set for id. Do I need to kick start the panel? will this delete config or passcodes? I am expecting the extra zones to appear as zone 9 onwards as the id is not set in the expander. I know the Menvier panels can be asked to rescan the system hardware, is this possible or nescessary on the 9954? Any advice would be much appreciated. Thank you Dave
