Search the Community
Showing results for tags 'texecom premier elite 48'.
-
Hello all, A few months back I installed a Texecom Premier Elite 48 control panel, with Ricochet PIR's, door contacts, a could of hard wired devices. Along-side this system, I wanted to be able to be alerted to any alarms so bought a GSM communicator plugin for it. The part number is CEG1000. The set-up took a few reads of the manual, but I got there and it was all working very well, it was tested, receiving messages, replying to them and alerting me if an alarm was activated. A few weeks after installation the system started beeping intermittently and gave me an error message: ATH Path Fault COM1 Fault No ATS Available. I put it into engineer mode, disconnected the communicator from COM1, opened it up, gave it a good old clean out and plugged it back in. The system happily accepted it and all was right in the security world. The device then started to throw this error again, and it grew more frequent, first a month, then a fortnight, a week, a day, an hour, and now it is a matter of seconds. I'm wondering if someone could point me towards exactly what I should be looking at, as the cause of the issue. I have verified the sim card works, the panel is communicating with the GSM device and vice versa. Having looked around the forum I have found many people with this error, but they all seem to be using the DigiCom devices which are connected to the phone lines. The GSM module was bought second hand, so I am aware that this may play a part, but before I get in contact with the person it was purchased from, I want to make sure I rule out all other problems. Anything I can try and test would be greatly appreciated. John Picture of device: http://imgur.com/a/F3BU0 Picture of model: http://imgur.com/a/10vou
- 24 replies
-
- texecom premier elite 48
- gprs
-
(and 2 more)
Tagged with: