Optima Gen4

[Ringlex]

Panel installed using wiring of old optima panel.3 PIR's 2 PA,s and 2 door conns together with Siren and Strobe.PIR,s pick up movement,PA's work,strobe works and Siren works in panel tamper mode.When keying in code, 5 6 7&8 light up, warning sound is heard and that is as far as it goes and

will continue until code is put in again.Top red light and bottom green is on but panel lights 2 3&4 will light and speaker beeps when a PIR lights up.

Any thoughts

James Wilson has been very helpful for which I am grateful

[james.wilson]

Have you linked out the unused zones.

Also can you upload a picture of how its wired in the panel.

[mma]

You have an open zone or have the exit mode as exit terminate.

[Ringlex]

Have you linked out the unused zones.

Also can you upload a picture of how its wired in the panel.

Have linked out the unused zones and now the panel is working as it should except that it beeps all the time as if a walk test was being activated.Tried to upload a picture hope you got it.

[Guest Oxo]

Have you got "chime" turned on?

[james.wilson]

As above you have chime on the relevant circuits.

also no picture.

[Ringlex]

To James Wilson and OXO

Many thanks for your help. All is well with the system now.

TTFN Ringlex

[james.wilson]

Anytime

[Guest Oxo]

No worries, cya.