Concept Panel To Challenger Bell Box

[seanxb]

Afternoon,

 

After much searching and nearly getting there, I still have 1 hurdle to overcome.

 

I have a Concept Panel and I have replaced my old bell box with a Challenger AU1000WBX. All is working except for the strobe, which frustratingly is not!

 

I have made the following connections. Could someone possibly advise where I may have gone wrong?

 

Bellbox STB-     to     Panel Strobe-

Bellbox 12V+     to     Panel D Bell

Bellbox 12V-      to     Panel A  0 Volts

Bellbox Tamper to     Panel T Tamper Return

Bellbox Trig -     to     Panel B Trig

 

I would have expected that the Strobe + in the panel would also have to be connected in the Bell Box nut I was initially advised not to

 

I have attached a view of the panel and bell box connections from the manuals. Any help would be appreciated.

 

Sean.

Alarm.pdf

[james.wilson]

Is the strobe output working?

[sixwheeledbeast]

Yep seems wired correctly. Test the output with a multimeter.

[seanxb]

I'm not sure if the output is working.

 

I do I have a multimeter but unsure how to test. Could you advise please?

 

Thank you.

[james.wilson]

Put your meter on 20v dc and see if there is 12 - 14v across strobe pos and neg when it should be going.

[al-yeti]

Or swap the bell and strobe see if it works