Honeywell Accenta G4 Speaker Problem

[hundleton1]

hi all just replaced the pannel at my perants. all good apart from my internal speaker, no sound at all from it at all, it's a 16 ohm unit, Iv double checked all wireing and I'm in the speaker connections on th board, I have tested the speaker and it good, I have also checked the vol pot on the board and still no joy

any one got any ideas ?

[datadiffusion]

Speaker fuse ok?

 

Resistance of the wiring to the speaker, measured at the panel when shorted at the far end = ?

Edited October 26, 2014 by datadiffusion

[hundleton1]

Well resolved it sort of. The speaker is only on 4 foot of cable. Pannel in airing cupboard up stairs and keypad down in kitchen. After further testing is it actually working but very quietly. Can even hear it from 8 foot away. Tried the volume controle no diferances.

It's a Knight Small Teletone Speaker , it's only small but thought I would get a bit of sound out of it

[norman]

Check it's not terminating via a resistor in the speaker.

[hundleton1]

I did check that funny enough and it straight to the speaker. Sorry I meant can't hear it from 8 foot, only when you a foot or so you can just hear it. Got my suspicions on this thing now. Any ideas what teletone is ? Looking at the sheet from the website it list frequency responce as 4khz not range of frequencys. I'm guessing this is for something else ? Phone tones perhaps

[james.wilson]

I would say its failed. Its is a security sounder

[efficient_systems]

I know this is an old thread now but just in case, the blue volume control pot on the control panel in this system is anti-clockwise for louder, clockwise for quieter.

 

I know this is counter intuitive but this is how it is designed! The type of pot they have used is usually for mounting on the reverse side of the board, I guess they just had them left over from an older design or something.

 

Hope this helps.