chris77 Posted March 12, 2015 Posted March 12, 2015 I have a G2-20 panel with RF and a 8 rio added using 3 groups, 1 house 2-3 out buildings. I have noticed a few times if 1u 2s 3s and there is a mains fail groups 2-3 unset. Need to double check what happens when all are set and mains fail. The panel reports mains fail on G2-20 and P Rio. But why is the system unsetting the other 2 groups when mains fails both units have good batteries? Quote
al-yeti Posted March 13, 2015 Posted March 13, 2015 Does the system remain Powered when removing mains? And you need to check what devices are on what zones to be sure which buildings are on which groups Quote
chris77 Posted March 13, 2015 Author Posted March 13, 2015 Yes the system runs fine on battery, there are two one in main panel and another in powered rio, batteries check out ok and I don't get any battery faults on panel. I seem to remember the RF G3 had too be assigned to a zone for groups, main panel was full these are all house sensors ie G1, the P-RIO is for an outbuilding G2 but not all 8 were used so assigned it to a un used zone on there, but not sure why his would cause the mains fail to unset. Quote
james.wilson Posted March 13, 2015 Posted March 13, 2015 Unless you have something into a zone programmed as keyswitch i can only assume its a bug. What firmware version are you running Quote securitywarehouse Security Supplies from Security Warehouse Trade Members please contact us for your TSI vetted trade discount.
Nova-Security Posted March 13, 2015 Posted March 13, 2015 Seen something before like this where one of our numptys wired to 12v from the panel to a Smart Rio Quote www.nova-security.co.uk www.nsiapproved.co.uk No PMs please unless i know you or you are using this board with your proper name.
james.wilson Posted March 13, 2015 Posted March 13, 2015 Seen something before like this where one of our numptys wired to 12v from the panel to a Smart Rio thats a hard issue not a software one? Quote securitywarehouse Security Supplies from Security Warehouse Trade Members please contact us for your TSI vetted trade discount.
al-yeti Posted March 14, 2015 Posted March 14, 2015 thats a hard issue not a software one? Could still disturb a bug no? Quote
Nova-Security Posted March 14, 2015 Posted March 14, 2015 thats a hard issue not a software one? Not had a firmware issue for years and then it was only on G3 panels Quote www.nova-security.co.uk www.nsiapproved.co.uk No PMs please unless i know you or you are using this board with your proper name.
timmo66 Posted March 14, 2015 Posted March 14, 2015 12v incoming to a smart Rio can cause all sorts of issues. To be honest though I've seen it done many a time and no problems whatsoever. In fact, I'm guilty, when we first started using them I did it on my first smart Rio. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.