dwdave Posted July 3, 2015 Author Posted July 3, 2015 Yeah it sure is. I'll put some case fans in there to help push the air. around Quote 'till the next question ...
james.wilson Posted July 4, 2015 Posted July 4, 2015 The controls will probably deal with it, the batt won't though Quote securitywarehouse Security Supplies from Security Warehouse Trade Members please contact us for your TSI vetted trade discount.
Nova-Security Posted July 4, 2015 Posted July 4, 2015 and capacitors on the board Quote www.nova-security.co.uk www.nsiapproved.co.uk No PMs please unless i know you or you are using this board with your proper name.
dwdave Posted July 24, 2015 Author Posted July 24, 2015 (edited) The LED on the RS232 board - is it supposed to mimic the other LEDS in terms of connection to the panel etc  ie - slow long flash - no / bad AB comms    quick flash  - good AB comms  Only reason I ask is that my Gold connection has stopped working and now the only led that remains operational is the one which is slowly blinking.  I reset the PC, the Alarm and removed and re-added the board. But the panel no longer recognises that the RS232 board has been reconnected. Edited July 24, 2015 by dwdave Quote 'till the next question ...
GalaxyGuy Posted July 24, 2015 Posted July 24, 2015 This is a bus device, so entering and exiting engineering mode should re-enumerate it onto the RS485 bus. Resetting the alarm should also achieve the same though... Did you power cycle the module itself. If it has hung, then it will not re-join. Very old tech now - get a G3 or Dimension at least the 232 is built in Quote
al-yeti Posted July 24, 2015 Posted July 24, 2015 Dimension cheap on eBay man , now that experiment over , you won't regret swapping over Quote
dwdave Posted July 24, 2015 Author Posted July 24, 2015 I have power cycled the module - by removing it completely and clearing the mem sw. Â When I reconnect it, the led blinks to report bad AB. Â Is there a "wanted" part for non trade on this forum? I just cant justify changing out the panel when I havent even finished the install yet - will it mean new keypads etc? Quote 'till the next question ...
dwdave Posted July 24, 2015 Author Posted July 24, 2015 Exited engineer mode again and now I have a good AB line. Â Not sure what was going on there. Â Now I have created a "new" site on GalGold and I have not set a password, dialled into the site and it asks for a password. Leave it blank and it sits for a while before saying it cant communicate with remote module. Â At least I know the module is connected to the panel. Its the PC to RS232 Module thats the problem now Quote 'till the next question ...
dwdave Posted July 24, 2015 Author Posted July 24, 2015 I couldnt tell you what MK they are by looking at them to be honest. Quote 'till the next question ...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.