enasecurity Posted December 15, 2015 Posted December 15, 2015 Evening all, I have a premier 88 that was purchased new but only installed 6 months ago in replacement of my old menvier panel. It has been working flawlessly since today... It seems like one of the zones is stuck in walk test mode. When the zone is opened the keypad and internal speaker produce the walk test/fault tone. I have been on the phone with texecom and tried unprogramming the zone, entering and exiting walk test, powering down the panel....everything! And it still seems to be stuck. The system still operates fine though. Has anyone else come across this problem? It seems very strange! Thanks Quote
james.wilson Posted December 15, 2015 Posted December 15, 2015 i wouldnt say its a problem thats general. You dont have a smoke detector in that area do u? Quote securitywarehouse Security Supplies from Security Warehouse Trade Members please contact us for your TSI vetted trade discount.
enasecurity Posted December 16, 2015 Author Posted December 16, 2015 Hi James. The system has no smoke detection connected to it. Are there any settings in wintex that I should look out for? Quote
al-yeti Posted December 16, 2015 Posted December 16, 2015 What happens if you turn off chime on every zone and any global General setting Quote
Adi Posted December 16, 2015 Posted December 16, 2015 chime Quote I really can't be ar**** with it anymore.
sixwheeledbeast Posted December 16, 2015 Posted December 16, 2015 Zone programmed as Chime. Press the Chime button it will go away. Quote
enasecurity Posted December 16, 2015 Author Posted December 16, 2015 I have no chime zones setup. I have rebooted the panel again and it seems to have sorted it. Texecom mentioned going into udl/Digi options and pressing yes 20 times. Does this do a soft Restart? Thanks again I have no chime zones setup. I have rebooted the panel again and it seems to have sorted it. Texecom mentioned going into udl/Digi options and pressing yes 20 times. Does this do a soft Restart? Thanks again Quote
sixwheeledbeast Posted December 16, 2015 Posted December 16, 2015 Suppose that one way to get people off the phone... That is Reset Digi, I assume. If you have no chime zones then it maybe be something odd. Take a backup with Wintex and default the panel, try from there to rule out hardware issue. Quote
datadiffusion Posted December 16, 2015 Posted December 16, 2015 Texecom mentioned going into udl/Digi options and pressing yes 20 times. Texe installers, is this a real command? Quote So, I've decided to take my work back underground.... to stop it falling into the wrong hands
MrHappy Posted December 16, 2015 Posted December 16, 2015 I've had a handful of premiers with "sticky" zones You program it to "X" but it behaves as "Y" eg- walkthough zone that goes into alarm during entry, (& when you check its deffo programmed correct) program it off, come out of engineering. Go back & put it back to walkthough & its fine I've experienced the same thing with other panels (either a optima+2, 9800 or TS790 forget which or maybe all?) Quote Mr Veritas God
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.