Scantronic9600 keypad

[Gaz H]

Keypad said battery fault I didn't know if keypad had separate internal battery so removed cover, no battery so replaced.

Got new battery for mains panel,battery fault now gone, but now saying key pad needs reset any ideas anybody

[sixwheeledbeast]

Keypad tamper microswitch is open

[datadiffusion]

Very fiddly tamper switches on the original 9800 and all 9600 keypads, be prepared to 'pad out' the tamper switch plastic tongue on the 'wall' side...

[sixwheeledbeast]

...or whatever is rolling about in your van; chewing gum, sticky pads, insulation tape, penny washers all seem to be appropriate methods, if stuff I have ripped out is anything to go by.

[MrHappy]

I though you where meant to put a plug & screw under the plastic tamper tab & adjust the height of the screw head to suit ?

[Rulland]

Many ways to skin a cat, each to their own, right or wrong!.

[MrHappy]

When I was younger  & slimer  I got bored of tossing about with call back & bits of card & start with a screw for the tamper tab,

 

sadly nobody done a rkp as slim & stylish as 9825 /9625 since scanny late 80's effort

[james.wilson]

texe new lot might?

[norman]

25 minutes ago, james.wilson said:

texe new lot 

lol

[sixwheeledbeast]

9 hours ago, MrHappy said:

sadly nobody done a rkp as slim & stylish as 9825 /9625 since scanny late 80's effort

 

DSC?