Honeywell Accenta 8 G4 Mini Alarm System

[Dave S]

Hi, I am looking for help please. I have installed the above alarm at home and have a problem. I am getting the fault code ' Tamper Fault Lockout' I suspect the issue is with the bell box as everything else looks to be ok. It is a Honeywell AG6 Bell Box and when installing there was a sheet inside the box saying to wire differently to the installation manual. I have also tried another wiring diagram I found on a previous post n here but still no joy. It appears that there is only 1x tamper wire coming back from the bell box - Is this correct? I have the following terminals n the bell box - TR-, S-, V+, V-, ST- Can anyone confirm to which the T A D B wires from the control panel should go to?

 

Also any other ideas welcome. I have checked the tamper circuit from the Keypad and the PIR's and they are both ok and I have removed the auto dialler for now.

 

Any help would be much appreciated as I am all out of ideas.

 

Regards

 

Dave

Edited September 20, 2016 by Dave S

[james.wilson]

link out your tamper circuits to narrow it down first

[Dave S]

Hi James. Tried that already for pir sensors and key pad but not sure how to link out the bell box. 

[james.wilson]

Hold off neg to tamper return

t and a iirc

[Dave S]

Just put the meter across t & a and there is a open circuit. 

[Dave S]

I have T to tr-, A to v-, D to v+, B to s- and - to st-

[james.wilson]

yes link t to a. Disconnect all the san wiring first and while powered down etc

[Dave S]

San wiring??

[james.wilson]

sab autocorrect sorry

[Dave S]

Hi James. Thanksfor your help. Broken wire to the bell box. New length of cable run in and it's sorted

 

Dave