Dave S Posted September 20, 2016 Share Posted September 20, 2016 (edited) Hi, I am looking for help please. I have installed the above alarm at home and have a problem. I am getting the fault code ' Tamper Fault Lockout' I suspect the issue is with the bell box as everything else looks to be ok. It is a Honeywell AG6 Bell Box and when installing there was a sheet inside the box saying to wire differently to the installation manual. I have also tried another wiring diagram I found on a previous post n here but still no joy. It appears that there is only 1x tamper wire coming back from the bell box - Is this correct? I have the following terminals n the bell box - TR-, S-, V+, V-, ST- Can anyone confirm to which the T A D B wires from the control panel should go to? Also any other ideas welcome. I have checked the tamper circuit from the Keypad and the PIR's and they are both ok and I have removed the auto dialler for now. Any help would be much appreciated as I am all out of ideas. Regards Dave Edited September 20, 2016 by Dave S Quote Link to comment Share on other sites More sharing options...
james.wilson Posted September 20, 2016 Share Posted September 20, 2016 link out your tamper circuits to narrow it down first Quote securitywarehouse Security Supplies from Security Warehouse Trade Members please contact us for your TSI vetted trade discount. Link to comment Share on other sites More sharing options...
Dave S Posted September 20, 2016 Author Share Posted September 20, 2016 Hi James. Tried that already for pir sensors and key pad but not sure how to link out the bell box. Quote Link to comment Share on other sites More sharing options...
james.wilson Posted September 20, 2016 Share Posted September 20, 2016 Hold off neg to tamper return t and a iirc Quote securitywarehouse Security Supplies from Security Warehouse Trade Members please contact us for your TSI vetted trade discount. Link to comment Share on other sites More sharing options...
Dave S Posted September 20, 2016 Author Share Posted September 20, 2016 Just put the meter across t & a and there is a open circuit. Quote Link to comment Share on other sites More sharing options...
Dave S Posted September 20, 2016 Author Share Posted September 20, 2016 I have T to tr-, A to v-, D to v+, B to s- and - to st- Quote Link to comment Share on other sites More sharing options...
james.wilson Posted September 20, 2016 Share Posted September 20, 2016 yes link t to a. Disconnect all the san wiring first and while powered down etc Quote securitywarehouse Security Supplies from Security Warehouse Trade Members please contact us for your TSI vetted trade discount. Link to comment Share on other sites More sharing options...
Dave S Posted September 21, 2016 Author Share Posted September 21, 2016 San wiring?? Quote Link to comment Share on other sites More sharing options...
james.wilson Posted September 21, 2016 Share Posted September 21, 2016 sab autocorrect sorry Quote securitywarehouse Security Supplies from Security Warehouse Trade Members please contact us for your TSI vetted trade discount. Link to comment Share on other sites More sharing options...
Dave S Posted September 24, 2016 Author Share Posted September 24, 2016 Hi James. Thanksfor your help. Broken wire to the bell box. New length of cable run in and it's sorted Dave Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.