Help with Enforcer remote software

[shaun c]

Hi Guys

 

I've just registered as a new member. Security engineer for 15 years or so. I have juts purchased a Pyronix Enforcer Wi-Fi V10 to have a play. Has anyone used or managed to use the remote software for the PC to allow remote diagnostics etc.? Ive downloaded it from Pyronix but seems as this does support the Enforcer Panel?

 

Any help would be appreciated

 

Thanks

 

Shaun

[Simlec]

(Have not tried it with V10 but should be no different)

The Enforcer works fine with remote software InSite UK.

Are your PC & panel on the same network? could be the problem.  Have you got the cloud & IP indicators green at the bottom of software? 

[shaun c]

Hi thanks for your reply. Ive not really played with it that much as yet but when i looked one of the drop down boxes for panel type nothing was listed enforcer?!

[james.wilson]

I think its a euro meridian under the skin

[shaun c]

James will look at it again just wondered if any one else had found it a little confusing to work on! 

[al-yeti]

3 hours ago, shaun c said:

James will look at it again just wondered if any one else had found it a little confusing to work on! 

They are Real alarm men , unlikely

[jiml]

PM me your email address and I will send you access to our training videos. There's I full details on how to setup Insite with v10 enforcer.  

Tip. Use roving dual then Insite works out the panel type.