Any Scan ion 16 experts...

[ian.cant]

Firmware probably doesnt match as I found out recently trying to add an expander to an Ion 160, contact Eaton Tech support desk for confirmation.

 

[Rabmcnaught]

Thanks for the reply’s everyone, appreciated 

 

ian would this be still the case as I have the new contact workings fitted on zone 1, it was mainly to rule out a faulty contact. 

 

But still cant add in a 9th zone, that now being the old original contact. 

 

One minute I can’t clear the Tamper then when I delete it and re-learn it the fault will change to the door showing open and not walk testing, it’s strange when the Tamper fault exists it walk tests fine, the next time after I re-learn it will tell me zone is open and not seeing any Tamper.

 

Bizarre, also Eaton won’t talk to me as I’m not a company and just doing it diy. 

Edited May 26, 2018 by Rabmcnaught

[petrolhead]

On 26/05/2018 at 23:04, Rabmcnaught said:

Thanks for the reply’s everyone, appreciated 

 

ian would this be still the case as I have the new contact workings fitted on zone 1, it was mainly to rule out a faulty contact. 

 

But still cant add in a 9th zone, that now being the old original contact. 

 

One minute I can’t clear the Tamper then when I delete it and re-learn it the fault will change to the door showing open and not walk testing, it’s strange when the Tamper fault exists it walk tests fine, the next time after I re-learn it will tell me zone is open and not seeing any Tamper.

 

Bizarre, also Eaton won’t talk to me as I’m not a company and just doing it diy. 

Pm sent

[magpye]

On 26/05/2018 at 23:04, Rabmcnaught said:

Bizarre, also Eaton won’t talk to me as I’m not a company and just doing it diy. 

Good to see that there are stll a few manufactures still keep information 'in house'