Net2 Paxton intergration to Texecom Alarm

[forumflyer]

Hi,

 

I have a client wanting me to connect up a paxton net2 unit with a texecom alarm system as it should be able to unset and set the alarm on entry and exit.

 

The problem i have is paxton diagram is not that clear.

 

It says i need an momentary key switch input 2 wires this is coming off a relay (where do i wire these to on the texe?)

 

And also from the alarm it want a voltage free status output again 2 wires, where do they go and what colours

 

Seems very hard to find an answer on this considering paxton sell alot of these units!

 

Thanks

 

 

[james.wilson]

the from alarm pair is an open close clean switch to show the paxton if its armed or not.

the to pair will go to a zone programmed as keyswitch momentary

[forumflyer]

Thanks for your swift responce

 

So the from alarm (texe unit) which two am i wiring it from on the texe board

 

[james.wilson]

from a relay that operates when the system is armed

[sixwheeledbeast]

Would require dedicated ACU to conform to BS8243, probably not applicable here but worth mentioning.

Texe only have closed contacts on the 88 and up.