Gav1978 Posted November 11, 2018 Share Posted November 11, 2018 Hello, I'm sure it is possible but am struggling to find out how to do it. I would like the bellbox to display a form of flashing LED when armed. I would be grateful for any support or guidance with this. Thank you Quote Link to comment Share on other sites More sharing options...
PeterJames Posted November 11, 2018 Share Posted November 11, 2018 EN50131 says there should be no visible indication to show that an alarm system is armed, so I would think it highly unlikely that it is in the programming of any system, even Pyronix Quote Link to comment Share on other sites More sharing options...
Amps Posted November 12, 2018 Share Posted November 12, 2018 The comfort LEDS are either enabled or disabled and that’s it. There is no input to trigger them. The status is determined by a link on the siren pcb. Quote Link to comment Share on other sites More sharing options...
Monty Posted November 12, 2018 Share Posted November 12, 2018 Are you looking for the strobe to give you conformation of setting /unset coopers panels can give you a 3 strobe flash on both so might be in setting progg Quote www.AllanMoncrieffAlarms.com Link to comment Share on other sites More sharing options...
al-yeti Posted November 12, 2018 Share Posted November 12, 2018 19 hours ago, Gav1978 said: Hello, I'm sure it is possible but am struggling to find out how to do it. I would like the bellbox to display a form of flashing LED when armed. I would be grateful for any support or guidance with this. Thank you Or your basically using a wireless bellbox and it has no flashing LEDs in general Only option is to put in a wired bell Quote Link to comment Share on other sites More sharing options...
Amps Posted November 12, 2018 Share Posted November 12, 2018 40 minutes ago, al-yeti said: Or your basically using a wireless bellbox and it has no flashing LEDs in general Only option is to put in a wired bell The Pyronix wireless bell box has the option to enable/disable ‘comfort’ flashing LED’s. Quote Link to comment Share on other sites More sharing options...
Amps Posted November 12, 2018 Share Posted November 12, 2018 Quote Link to comment Share on other sites More sharing options...
al-yeti Posted November 12, 2018 Share Posted November 12, 2018 1 hour ago, Amps said: The Pyronix wireless bell box has the option to enable/disable ‘comfort’ flashing LED’s. Battery's last long? Quote Link to comment Share on other sites More sharing options...
Amps Posted November 12, 2018 Share Posted November 12, 2018 1 hour ago, al-yeti said: Battery's last long? Dunno. Quote Link to comment Share on other sites More sharing options...
al-yeti Posted November 12, 2018 Share Posted November 12, 2018 46 minutes ago, Amps said: Dunno. Ah ok, was going to compare with hkc, they have additional battery pack gives you 24-36 months approx depending on flash rate , otherwise single normal pack will give you 6months Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.