Premiere Elite 24 external sounders off during part set at night.

[Leckybill]

Hi There

 

Can anyone tell me how to turn off the external sounders (sab) On part set for night time use 

, I can’t seem to find it in the set up instructions, had this option on our previous Veritas 8 system.

My new system is the Texecom Elite 24 

 

thanks

 

Bill

[sixwheeledbeast]

That's not an out of the box option on a Premier. It's not something that you would normally do.

You would need to use custom outputs to do custom things. Something like have a stage for Bell SAB and a Inverted stage for Part armed.

Alternatively if it's concern for waking the neighbours in the night you can set the part set bell delay timer to whatever time you feel.

[Leckybill]

Thanks for your help I’ll have a look at that, yes it’s about not disturbing the neighbours, I’ve put a small toggle switch on the bell output until I can resolve the issue.

 

Cheers Bill.

[al-yeti]

13 minutes ago, Leckybill said:

, I’ve put a small toggle switch on the bell output until I can resolve the issue.

 

 

Lol

[sixwheeledbeast]

Toggle switch like that is far from ideal.

If it fails, you forget to switch it or it is found in a break in, your alarm is useless.

The design behind a self activating bell is that everything is contained within it and only controlled by the panel so they are harder to defeat in a break in.

I would suggest a small part set bell delay is the most appropriate. 

[james.wilson]

Could you use an intruder output with a 15 min confirm timer and then disable comms in part set. Afraid I don't know the panel at all

[sixwheeledbeast]

That is another way but would require a little more setup over what I posted in post2 you would need adjust pulse timers then.

Also have the issue of the bell not triggering on a tamper if you use "intruder".

[james.wilson]

True good shout

[al-yeti]

2 hours ago, james.wilson said:

Could you use an intruder output with a 15 min confirm timer and then disable comms in part set. Afraid I don't know the panel at all

Why disable coms?

[james.wilson]

Because if comms are enabled for part set may as well use the bell output