DanTheManUK Posted December 16, 2019 Posted December 16, 2019 Hello all. It’s been a while, my Honeywell SL compact has gone a bit mental again. PIR was triggered in an outbuilding and in an attempt to silence it, we seem to have slipped into programming mode (i think) and for the life of me cannot get out of this mode. Please if anyone is familiar with this system - and can assist in walking me out of the current state back into Day mode....? I would be forever great full..... Quote
al-yeti Posted December 16, 2019 Posted December 16, 2019 Just now, DanTheManUK said: Hello all. It’s been a while, my Honeywell SL compact has gone a bit mental again. PIR was triggered in an outbuilding and in an attempt to silence it, we seem to have slipped into programming mode (i think) and for the life of me cannot get out of this mode. Please if anyone is familiar with this system - and can assist in walking me out of the current state back into Day mode....? I would be forever great full..... Looks like tamper to me , unless another light flashing? Quote
DanTheManUK Posted December 16, 2019 Author Posted December 16, 2019 Al Yeti - correct !! Following the incident, I intentionally triggered a tamper, in the hope to access the main menu. Didn’t work though.... Quote
DanTheManUK Posted December 16, 2019 Author Posted December 16, 2019 sixwheeledbeast- currently, yes tamper still open. I’ve not been able to ‘step back’ Quote
sixwheeledbeast Posted December 16, 2019 Posted December 16, 2019 it won't reset with the tamper open Quote
DanTheManUK Posted December 16, 2019 Author Posted December 16, 2019 Logan - I have tried re-setting and it’s not gone as expected or come out of prog mode (which is where I think it is) so ideally need to work out what state panel is currently in & walk back. See pic of main panel below (any instructions to Re-set very welcome) Quote
DanTheManUK Posted December 16, 2019 Author Posted December 16, 2019 Gents, once again you guys have helped me restore the system. I’ve finally managed to step back out of the state panel was in & Re-set [code, 8, engineer code] and it’s back into Day Mode. not entirely sure why / how this happened, but thanks for steering me into the right direction. Quote
Amps Posted December 17, 2019 Posted December 17, 2019 12 hours ago, Logan said: Press reset. Have you tried that. Please can you put a picture of the main panel. As it It could be a accenta 6 Accenta 8 Optima compact 6+ Limited experience of these panels and always disliked them. I find the range of panels confusing. You know how many different types of Accenta/Optima panels there have been? Quote
datadiffusion Posted December 17, 2019 Posted December 17, 2019 Can't stand anything with confusing flashy codes to show various states - no need for it in this day and age. Quote So, I've decided to take my work back underground.... to stop it falling into the wrong hands
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.