Door sensor

[Smithy]

I have some ongoing issues with alarms. An understatement for sure especially for someone not in the trade . On a rear exit door is a magnetic door sensor. On replacing the battery firstly the alarm did not go off as per the other sensors, but also were blue and red lights on the frame sensor. These went away, but the alarm does not set (pyronix enforcer), and oddly when you put your finger near the sensor the blue light comes on. 

Any help appreciated

[al-yeti]

1 hour ago, Smithy said:

I have some ongoing issues with alarms. An understatement for sure especially for someone not in the trade . On a rear exit door is a magnetic door sensor. On replacing the battery firstly the alarm did not go off as per the other sensors, but also were blue and red lights on the frame sensor. These went away, but the alarm does not set (pyronix enforcer), and oddly when you put your finger near the sensor the blue light comes on. 

Any help appreciated

Blue light meaning PIR? So finger near it would be normal 

 

Maybe cover isn't on correctly or you snapped the back tamper plate?

 

Door sensor may not have triggered alarm if battery was completely flat perhaps

[Smithy]

Thanks for the thoughts but its not a PIR. It's a surface magnetic contact with tamper

[al-yeti]

1 hour ago, Smithy said:

Thanks for the thoughts but its not a PIR. It's a surface magnetic contact with tamper

Mashed up the board or tamper when you put.batyery in?