GD 48 Help

[David1]

Hi everyone, I am to this forum and I am looking for some advice. Have recently bought a GD 48 alarm, C037 keypad and standby battery, I have also replaced the on board button battery. My problem is that the keypad is showing ************ and I cannot get past this on power up. Have read previous posts with no success con anyone help. Thanks

[Nova-Security]

Check the keypad address 

[GalaxyGuy]

4 minutes ago, David1 said:

Hi everyone, I am to this forum and I am looking for some advice. Have recently bought a GD 48 alarm, C037 keypad and standby battery, I have also replaced the on board button battery. My problem is that the keypad is showing ************ and I cannot get past this on power up. Have read previous posts with no success con anyone help. Thanks

What is the red LED on the main panel PCB doing?

[David1]

The keypad address is set to 0 and there are no lights showing on the main board

[GalaxyGuy]

That's not right. Sounds like it's dead. When you apply power to a dimension, the relay should click and the red led should start flashing after about 5 seconds. 

 

I'm not sure it is one, but the £50 panels on eBay are £50 for a reason and are a bit of a gamble.

[David1]

Cheers sounds as though I’ve been done

 

[GalaxyGuy]

Was it sold as seen?

[David1]

I will have to check, as a matter of interest where is the led and relay situated on the board to check it is nothing obvious 

[al-yeti]

10 hours ago, David1 said:

Cheers sounds as though I’ve been done

 

Well off from eBay , just hit not as described, or PayPal upto 6months to open case 

 

 

Edited December 4, 2020 by al-yeti

[GalaxyGuy]

58 minutes ago, David1 said:

I will have to check, as a matter of interest where is the led and relay situated on the board to check it is nothing obvious 

Both on the left side. The relay is next to the telecom connectors and the led is near the rs232 connector.  If it doesn't click, it's not usually anything simple.