Intellisense (C&K 700L) Wrong Part Set Zone

[Jason1975]

The alarm in our home has been setup for part set (night) to be Zone 2 (which is a downstairs room) - I need it to be upstairs (currently zone 3).

 

Have been looking for a way to reprogram the control panel to switch to the correct zone - I realise I can just isolate Zone 3 at night, but would prefer to use the easier Part Set mode correctly (easier for everyone else to remember).

 

Is there a way of changing this? or is it a lost cause? I only have the user manual which doesn't detail this information unfortunately.

 

Any help would be appreciated 

[james.wilson]

It's an engineer menu option or you could swap the circuits around

[sixwheeledbeast]

Easiest would be swapping the circuits in the panel I suppose. That's if everything else is programmed correctly.