Anj Posted yesterday at 09:40 Share Posted yesterday at 09:40 I have Scantronic 9651 installed. Due to some work, the builder removed the fuse from the Fused Mains Spur connected to the Control Unit. Then he lost the fuse and never put it in for 3 weeks. The PIR beeped a lot and then went silent and the builder has left! I have replaced the 3Amp fuse but the Keypads have no power. What can I do? Quote Link to comment Share on other sites More sharing options...
al-yeti Posted yesterday at 12:16 Share Posted yesterday at 12:16 2 hours ago, Anj said: I have Scantronic 9651 installed. Due to some work, the builder removed the fuse from the Fused Mains Spur connected to the Control Unit. Then he lost the fuse and never put it in for 3 weeks. The PIR beeped a lot and then went silent and the builder has left! I have replaced the 3Amp fuse but the Keypads have no power. What can I do? Unless you have some knowledge for this it will be difficult. I would remove the fuse again You need logically check for electrical power , How do you know the mains power is not disconnected somewhere? After inserting fuse that would be your first check , by maybe using a mains tester. Quote Link to comment Share on other sites More sharing options...
sixwheeledbeast Posted 18 hours ago Share Posted 18 hours ago If your not sure, it's time to call an alarm engineer. The standby battery in the system will be drained and is possibly stopping the system from booting, assuming there is no other damage to the system that needs repair as well... Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.