Texecom Premier Elite new install, external bell box siren not working

[JPW]

6 hours ago, sixwheeledbeast said:

What are the comfort LED's doing?

Have you triggered it with a bell test or giving the trigger a negative.

 

Comfort LED's are normal, alternating between the left and right LED's inside the box.

 

On the keypad, if I go to Engineer Utils > Bell Test > On, the bell correctly sounds. Same for strobe when I test. This is the strange thing. The wiring must check out as the bell works when testing from the keypad respectively?

 

Edited Tuesday at 07:54 by JPW

[norman]

Did you factory default the panel on initial power up? 

[JPW]

46 minutes ago, norman said:

Did you factory default the panel on initial power up? 

 

Good question. I did not, assuming a brand new panel out the box would have an erased memory?

[sixwheeledbeast]

So you've proven the wiring and that it's likely the programming...

Yes, you should always default them from new.

[james.wilson]

If you swap the bell and strobe terminals in the panel does the bell sound and the strobe not activate? 

[JPW]

1 hour ago, james.wilson said:

If you swap the bell and strobe terminals in the panel does the bell sound and the strobe not activate? 

 

Great idea, I will try this when back on site.

[MrHappy]

since 30 years ago or whatever....

 

most 4737 / g2 bells on little jobs will have been wired at panel end by adding +/- then shorting the ring & return together before putting all the wires in the panel

[al-yeti]

5 hours ago, JPW said:

 

Great idea, I will try this when back on site.

Dude 100% in error you have changed something on the outputs